Skip to main content

Slim Shots

Slim Shots Header
How to Mix Retatrutide – Reconstitution Guide (BAC Water) | Slim Shots
Retatrutide

How to Mix Retatrutide

Reconstitution Guide: BAC Water Ratio & Dosing Chart

Always consult a healthcare professional before starting any injection protocol.

Home / Administration Guide / How to Mix Retatrutide

Why Reconstitution Matters

Retatrutide is supplied as a freeze-dried powder and must be reconstituted with bacteriostatic water (BAC water) before it can be injected. Because Retatrutide is a potent triple agonist, an incorrect mixing ratio can significantly over- or under-dose you — always double-check the ratio below before drawing your dose.

📊 Reconstitution Ratio

Vial SizeBAC Water AddedFinal Concentration
10mg vial1.0ml10mg/ml (100 units = 10mg)

🧪 Step-by-Step Mixing Instructions

1

Wash your hands

Wash thoroughly with soap and water for at least 20 seconds and dry with a clean towel.

2

Swab both vial tops

Clean the rubber stopper on your Retatrutide vial and your BAC water vial with a fresh alcohol swab each. Let air-dry for 10 seconds.

3

Draw 1.0ml of BAC water

Using a syringe, draw exactly 1.0ml of bacteriostatic water from its vial.

4

Inject slowly down the vial wall

Angle the needle so the water runs down the inside of the glass onto the powder — do not squirt it directly onto the powder.

Never shake the vial. Gently swirl until fully dissolved.
5

Check the solution is clear

It should be clear and colourless with no particles. Discard if cloudy or discoloured.

6

Label and refrigerate

Write the mixing date on the vial. Store at 2–8°C and use within 28 days.

📅 Dose to Unit Conversion (10mg vial, 1.0ml BAC)

DoseUnits (U-100)Volume
2.0mg20 Units0.20ml
4.0mg40 Units0.40ml
8.0mg80 Units0.80ml
12.0mg120 Units1.20ml
Note: Doses at 12mg require slightly over 100 units — use a 1.5ml or 3ml syringe with clear ml markings for accuracy at this level.

Retatrutide Mixing FAQs

How much BAC water do I add to a Retatrutide vial?

Add 1.0ml of bacteriostatic water to a 10mg vial, giving a 10mg/ml concentration — 100 units on a U-100 syringe equals 1.0ml equals 10mg.

Can I use sterile water instead of BAC water?

No. Sterile water has no preservative and the solution must be used immediately. Bacteriostatic water allows fridge storage for up to 28 days.

Why does Retatrutide need such careful mixing?

As a triple GLP-1/GIP/glucagon agonist, Retatrutide is potent even at low doses. An inaccurate BAC water ratio changes the concentration and can significantly alter the actual mg dose delivered — always measure precisely.

How long does mixed Retatrutide last?

Once reconstituted, store in the fridge at 2–8°C and use within 28 days. Label the vial with the mixing date.